Comms Pad Behind The Head: Clear Radio Comms Setup
By LOYAL TO THE MISSION | Published: 2026-10-17
Category: How-to Guides
Learn how to install and use a behind-the-head comms pad for better radio communication under a helmet. Step-by-step guide with common mistakes to avoid.
Quick answer
A behind-the-head comms pad improves radio communication by keeping your headset securely in place under a helmet. Install it by attaching the pad to your headband or helmet straps, then route the comms cable to avoid snagging.
Why a Comms Pad Matters for Radio Comms
A comms pad, like the Comms Pad - Behind The Head, provides a lightweight laser-cut strap that increases comfort and breathability under a helmet. It helps keep your headset stable during movement, which is critical for clear radio communication in tactical or field environments.
This pad fits most behind-the-head headsets such as MSA Sordin and TCI Liberator. However, it does not fit Peltor Comtac Behind the Head models, so check compatibility before purchasing.
What You'll Need for the Setup
You'll need the comms pad, your behind-the-head headset, and a helmet with a suspension system. Optionally, a cable management clip or Velcro strap can help route the comms cable cleanly.
Step-by-Step Setup Guide
- Step 1: Attach the Comms Pad to Your Headband: Remove your headset from your helmet. Align the comms pad with the headband of your behind-the-head headset. The pad should sit between the headband and your head, with the laser-cut holes facing outward for breathability. Secure it using the built-in Velcro or straps. Common mistake: Attaching the pad too loosely. Ensure it's snug so the headset doesn't shift during movement.
- Step 2: Route the Comms Cable: Feed the comms cable from your headset through the cutouts or channels on the pad. This keeps the cable flat against your head and prevents it from catching on gear. Use a small Velcro strap to secure any excess cable to the pad or helmet webbing. Checkpoint: Make sure the cable doesn't pinch or kink. A kinked cable can degrade audio quality.
- Step 3: Fit the Helmet Over the Assembly: Place your helmet over your headset and comms pad. Adjust the helmet suspension so it sits evenly on the pad without pressing too hard on your ears. The pad should fill the gap between your head and the helmet shell, improving comfort and reducing hot spots. Common mistake: Over-tightening the helmet. You want firm contact, not pressure that causes discomfort after 30 minutes.
- Step 4: Test Radio Communication: With the helmet and headset in place, perform a radio check. Speak normally and ask for a signal report. If your voice sounds muffled or the radio cuts out, adjust the headset position or cable routing. The pad should not interfere with the microphone placement. Checkpoint: If audio is unclear, check that the headset speakers are aligned with your ears and the pad isn't blocking them.
Product Facts
- Comms Pad - Behind The Head: This lightweight laser cut headset strap increases comfort under helmets and breathability. Fits most behind the head headsets such as MSA Sordin, TCI Liberator, and many more. Made in the USA Berry Compliant. Does not fit Peltor Comtac Behind the Head. Ensures your headset stays comfortable and breathable during long missions, but verify compatibility with your specific headset model before purchase.
